Our flashtramp® lighting unit
LEDs
Two built-in high-performance LEDs make the flashtramp® lighting unit light up visibly.
Circuit board
The two high-performance LEDs are connected to the alternator via the circuit board.
Coil
A copper wire coil wound around the closed hollow bobbin.
Magnet
A neodymium magnet located in the hollow bobbin, which generates an induced voltage through movement.
Hollow bobbin
Made from PTFE plastic (Teflon), which has a very low friction coefficient.
Mold
The molded plastic material hardens flexibly and is heat and cold resistant, waterproof and UV-resistant.
Placements opportunities in flashtramp® module
